中文   |    English

Barcode Scanner, data capture Specialist in mainland China

Handheld Scanner, Fixed Mount Scanner, Desktop Scanner, Scan Engine, Data Collector

24-hour hotline:

+86-(0)755-29639948

Contact Us

Contact
Ms. Wang Xiaofeng (Sales Manager)

Mobile

Tel
+86-(0)755-29639948

Fax
+86-(0)755-29639948

Email
sale-wang@venture-iot.cn

Website
http://en.venture-iot.cn/

Address
Room 301, U6 Building, U8 Intelligent Manufacturing Industrial Park, Hangcheng Avenue, Baoan District, Shenzhen, Guangdong Province

Four cleaning steps make bar code scanner life longer

Four cleaning steps make bar code scanner life longer

Step / method:
1. Clean the shell
We all have the experience that when we directly wipe the dusty surface with a wet cloth, it will make the surface very flowery. Therefore, take a piece of dry and soft cotton cloth to remove the floating ash covered on the barcode scanner shell, and then wipe it again with a wet cloth, so that the dust can be basically "eliminated". If there are some other stains left on the shell at this time, we can dip some washing powder on the wet cloth to remove them. After cleaning up, use a clean wet cloth to wipe the area stained with washing powder several times.
When cleaning the shell, we should pay attention not to touch the glass plate of the barcode scanner, at the same time, we should also wring the wet cloth as far as possible to avoid dirty water flowing out of the flat glass during the wiping process.
2. Clean glass plate
After the shell is basically dry, open the upper cover of the barcode scanner, and use the blowing balloon to aim at the flat glass for several times, so as to "drive away" the dust attached to the surface. For the stains that cannot be blown away, it is necessary to clean them with glass cleaner, and then wipe them with soft dry cotton cloth. As whether the glass panel is clean or not is directly related to the scanning quality of the image, we must be careful when cleaning the panel.
3. Cleaning the internal optical components
Next, we can open the flat glass of the barcode scanner and clean the optical components inside the barcode scanner. Generally speaking, the case and base of the barcode scanner are stuck together, so it can be easily removed without a screwdriver. In the optical components, we should focus on cleaning the fluorescent tube of the barcode scanner: dip the absorbent cotton ball in distilled water, then squeeze the water on the cotton ball hard (to ensure that no water will flow out during the wiping process), and gently wipe it back on the lamp. Due to the precision of optical components, when cleaning these equipment, the action should be light and stable.
4. Clean the drive
The sliding bar on the transmission mechanism of barcode scanner is another key point we should pay attention to. Usually when there is noise in the process of barcode scanner, it is likely to be the problem of sliding bar. At this time, we can find some lubricating oil evenly applied on the sliding rod to improve the lubrication of the machinery in the transmission mechanism.
After the above cleaning work is completed, install and debug the barcode scanner in the correct order, and the cleaning of the barcode scanner is completed.
The maintenance of barcode scanner is relatively simple. The following points should be paid attention to:
1. Fall proof. The internal structure of barcode scanner is composed of decoder components and main board. These components are relatively precise components, so when using, it should be avoided to fall from a high place as far as possible, especially the glass components of barcode scanner. Once broken, dust will enter the barcode scanner.
2. Do not pull hard. Bar code scanner is composed of a wire rod and bar code gun itself. It is easy to loosen the connection by pulling the cable with force frequently, and it has poor contact during scanning.
3. Clean the glass baffle frequently.



QR code of mobile websitemobile website
Wechat QR code Wechat QR code